NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
NetGear MR60 Router - WiFi Connectivity Issue between two computers
Hello,
I have a MacBook with WiFi to connect to Internet. I have another computer (Jetson) that is also connected to Internet using Wifi. They both are on 5 GHz. channel. I cannot ping from my MacBook to Jetson and vice versa. I can confirm both are in Access Control -> Security Allowed. Is there a Router configuration that I should be paying attention?
Thank you,
Mustafa
4 Replies
Hello StephenB
Is this a continuation of your older discussion thread?
It is the same setup. The VPN service is still there. However now I am trying to connect the Jetson from my MacBook with WiFi because the Jetson is installed on the drone and there I need to be able to communicate with it in my back deck.
If you are still running V1.1.7.134_2.0.65.2 firmware, then start by updating it.
https://kb.netgear.com/000070298/MR60-MS60-Firmware-Version-1-1-8-142
I upgraded the firmware as mine was V1.1.7.134_2.0.65
Now I am able to ping Jetson from my MacBook. I am also able to ssh.
Now somewhat peculiar issue, one of the satellites wasn't able to come back online. It is having white blinking light.
Mustafa
Now I am able to ping Jetson from my MacBook. I am also able to ssh.
Great.
one of the satellites wasn't able to come back online. It is having white blinking light.
What have you tried (if anything) to resolve it?
I have a MacBook with WiFi to connect to Internet. I have another computer (Jetson) that is also connected to Internet using Wifi. They both are on 5 GHz. channel. I cannot ping from my MacBook to Jetson and vice versa. I can confirm both are in Access Control -> Security Allowed. Is there a Router configuration that I should be paying attention?
Is this a continuation of your older discussion thread?
- What firmware is the MR60 running?
- Can either machine ping the MR60 LAN address?
- Have you made sure that the Mac firewall doesn't have "Stealth mode" enabled? That would block Jetson attempts to ping the Mac (but not vice-versa).
- Are both machines connected to the same MR60 mesh element?
- Are both machines getting their IP addresses with DHCP?
FWIW, there is an old unresolved discussion thread here that is related:
- https://community.netgear.com/discussions/en-home-nighthawk-mesh-system/cannot-ping-the-device-in-same-network-mr60/2015192
If you are still running V1.1.7.134_2.0.65.2 firmware, then start by updating it.
- https://kb.netgear.com/000070298/MR60-MS60-Firmware-Version-1-1-8-142
What platform is the "Jetson" computer?
Jetson is an AI platform made by NVIDIA. They run Jetson Linux (formerly called Linux for Tegra). This is derived from Ubuntu.
What platform is the "Jetson" computer? Windows? Linux?
Be sure any firewalls or security apps are disabled on these PCs that could be blocking.
Armor or Smart Parental controls enabled by chance on the MR?
