RBK850 Routeur LAN configuration

Question

Hi&nbsp;I configured an RBK850 (without satellites for the present time) connected to ans ISP router (network 192.168.1.&lt;x&gt; with HDCP server). So, at the end of installation, my orbi network is 10.0.0.&lt;x&gt;. Wifi and LAN connections are working well and only one PC is connected to ORBI router with an Ethernet cable.&nbsp;&nbsp;I want to change the ORBI network to 192.168.2.&lt;x&gt;. So, I made the following modification&nbsp;- IP&nbsp;@ : 192.168.2.2- Mask : 255.255.255.0- DHCP from 192.168.2.10 to 192.168.2.254&nbsp;When I apply the modification, the router is restarted, the LED is white blinking during 1 mn and it restarts again and again. I've to reset it with default settings to stop the restart cycle. &nbsp;How to do such modification ? (it works perfectly on an old netgear router).&nbsp;&nbsp;Thanks&nbsp; Thierry&nbsp;&nbsp;PS : firmware version : V3.2.18.1&nbsp;

FURRYe38 · Answer

Did you power OFF the ISP router for 30 seconds then back on as well after you applied the change?&nbsp;&nbsp;Can you bridge the host router by chance? This is a double NAT condtion...

thierry38 · Answer

Yes, I powered off the ISP router and I can access to internet. I just received an answer for neatgear support

It seems the router DOES NOT support to have a 192.168.2.2 IP @. If I choose 192.168.2.1, it seems it’s working well.

I will continue tomorrow (11 PM in France now) And I will give you more information later. I lost several hours with the pb

Thanks

FURRYe38 · Answer

I now mine works on 192.168.0.1. I've never tried 2.1 though...Hmmm.&nbsp;Have a good night.&nbsp;

thierry38 · Answer

Hi,Just for information, with a router IP @ of 192.168.2.1 instead of 192.168.2.2, everything are working well.After this modification, I successfully- desactivate the router DHCP fonction (used instead a DHCP located on my network)- add two additional satellitesSo, it seems there is a bug in the orbi firmware which doesn’t support 192.168.2.2 as router addressBest regards

FURRYe38 · Answer

AH ya, Ok. I&nbsp; presume the RBRs IP address should always be .0 or .1. Maybe something NG put in. Most routers IP address usually end&nbsp; in .1&nbsp; anyways.&nbsp;&nbsp;Glad it's working now.&nbsp;Be sure to save off a back up configuration to file for safe keeping. Saves tine if a reset is needed.https://kb.netgear.com/000062080/How-do-I-back-up-the-configuration-settings-on-my-Orbi-WiFi-System&nbsp;Please mark your thread as solved so others will know.&nbsp;Enjoy.&nbsp;

Forum Discussion

RBK850 Routeur LAN configuration

5 Replies