Hi, Had Beta firmware 1.2.8.43-RC on my RAX120V2. Now I rolled back to 1.2.8.40. Main Reason for roll back was Temperature was showing NANC and auto fan wasn't working. After rolling back (without reset) temp still shows as NANC. What am I doing wrong ?

Not seeing this on my RAX120v2 on v.52 FW: There is no AUTO FAN. You can enabled it for being always ON but I believe this setting doesn't persist thru a power cycle or reboot of the router. MS Edge is browser I use. guccia123 ssssss

Netgear RAX120V2 NANC | NETGEAR Communities

10 Replies

FURRYe38
Guru
May 31, 2023
Factory reset and setup from scratch. Should clear our any lingering bad code. I believe NG disabling some of the debug items in the beta FW to help test for this reboot issue that was seen on v.40 FW. I would presume all this would be corrected and fixed in next official FW release.

Something to help with the internal fan, Install a laptop cooler fan under the router for 24/7 cooling.
- guccia123
  Aspirant
  May 31, 2023
  Thanks for fast response.
  
  When is full release expected of v43 firmware ?
  
  And will Restore settings via cfg work or should I manually enter all configs ?
  - FURRYe38
    Guru
    Jun 01, 2023
    No idea and version may not be v.43
    
    Manually setup from scratch then save off a new backup.
ssssss
Tutor
Jun 14, 2023
It unbelievable that it take more than a year for Netgear to fix a bug for a $300 router, and it still not done yet.
- guccia123
  Aspirant
  Nov 08, 2023
  Any fix on this problem ? I also have RAX120V2 had almost on all firmwares and Temperature Shows NaNc and auto fan doesn't work
  - FURRYe38
    Guru
    Nov 08, 2023
    Not seeing this on my RAX120v2 on v.52 FW:
    
    There is no AUTO FAN. You can enabled it for being always ON but I believe this setting doesn't persist thru a power cycle or reboot of the router.
    
    MS Edge is browser I use.
    
    guccia123 ssssss

Forum Discussion

Netgear RAX120V2 NANC