Netgear Nighthawk C7000v2 Wireless work fine but no wired connection via LAN

Question

Just purchased C7000 Nighthawk - installation was easy. worked with ISP provider Cox. No issues. Wireless is working fine. However, I cannot get the modem/router to recginzie any of the LAN ports. Have tried resetting and turned on and off. Netgear genie shows 3 of the 4 connected LAN and indicates that they are allowed. Lights on the back of the modem/router to the LAN ports are all yellow with occastional flash. No green lights.

Any suggestions in allowing the LAN ports to connect?

FURRYe38 · Answer

What LAN devices do you have connected?&nbsp;Be sure to swap out LAN cables with good quality cables, CAT6 is recommended.&nbsp;

Konanpa · Answer

I used the previous cable I had with prior device.&nbsp; They are CAT6 cables.&nbsp; Any other ideas on why these devices wouldn;t register.&nbsp; It is to my Samsung TV, Panasonic Blu-Ray and my Denon Receiver.

FURRYe38 · Answer

Do you have any wired devices that are working when wire connected or is all devices not working over wire?&nbsp;Has a factory reset and setup from scratch been performed since last update?&nbsp;

Forum Discussion

Netgear Nighthawk C7000v2 Wireless work fine but no wired connection via LAN

3 Replies