Moved EX6150v2 extender, the power is on but will not setup

Question

I recently purchased an EX6150v2 extender, I set it up on one side of the room, but had to move it. So, I plugged it into another wall in the same room. The power light is on but will not setup. I even attempted a factory reset and that didn't work. Any help would be greatly appreciated. Thank you.

wtyoung18 · Answer

Thank you, I will give it a try and give you an update

plemans · Answer

Only the power light is in and its amber?
Seems like a corrupt firmware issue.&nbsp;
You can try recoving it with tftp or nmrpflash. are you on windows? if so, follow this guidehttps://kb.netgear.com/000059634/How-to-upload-firmware-to-a-NETGEAR-router-using-Windows-TFTPjust make sure you enable tftp https://www.thewindowsclub.com/enable-tftp-windows-10and here's a video walk through using a tftp client. Use the built in one for windows 10 though. the video is more of an example of how its done. https://www.youtube.com/watch?v=R9DLrLQrpawand if that doesn't work, you can try using nmrpflashhttps://github.com/jclehner/nmrpflash

plemans · Answer

good luck!

Forum Discussion

Moved EX6150v2 extender, the power is on but will not setup

3 Replies