when i start my r6200 power led blinks continiously for 10 sec but everything is okay.. router is working fine... but why power led is blinking? i got this router from warranty... after previous one got brick..

Hi nayeemlinkin, Welcome to the community! Does it stay steady afterwards? If yes, that is part of the boot up process. Regards, Dexter Community Team

R6220- power led blink continiously for 10-12sec

4 Replies

DexterJB
NETGEAR Moderator
Apr 05, 2018
Hi nayeemlinkin,

Welcome to the community!

Does it stay steady afterwards? If yes, that is part of the boot up process.

Regards,

Dexter

Community Team
- nayeemlinkin
  Aspirant
  Apr 06, 2018
  yes it stay steady after 10/12 sec... but i have 2 Router, both of them are same model R6220.. one blink in start up another one never blink.... thanks
  - michaelkenward
    Guru
    Apr 06, 2018
    nayeemlinkin wrote:
    yes it stay steady after 10/12 sec... but i have 2 Router, both of them are same model R6220.. one blink in start up another one never blink.... thanks
    
    If you have two routers on the same network, you should configure them to avoid conflicts. Usually this means using one router in access point mode.
    
    There is a manual for the R6220 somewhere at the end of this link:
    
    >>> R6220 | Product | Support | NETGEAR <<<
    
    See page 127.

Forum Discussion

R6220- power led blink continiously for 10-12sec