NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.

Forum Discussion

pePaolo's avatar
pePaolo
Aspirant
Dec 10, 2016
Solved

Router pr2000 n300 Trek bricked

Hi there, this is Paolo, I have a Netgear pr2000 trek bricked by wrong firmware, green power led working, green internet led working, green usb led blinking, sometimes green wifi led blinking.

 

ipv4 manual ethernet 192.168.1.1 no response, no ping fron cmd line...

 

Someone can help me on this issue?

 

Thanks

Firmware

3 Replies

    • pePaolo's avatar
      pePaolo
      Aspirant
      Dec 12, 2016

      Elaine, Many thanks for your answer. I unsuccessfully tried many times this guide...

       

      1. Unplug all port connections from router except the PC you are using to upload.
      2. Turn router OFF for 10 seconds.
      3. Hold down the reset button on the back of router with a paper clip.
      4. Power ON the router while holding down the reset button.
      5. Watch the Power LED. It starts with orange color, and then will start flashing orange.
      6. Power LED will then turn to flashing green. Count at least 10 flashing green LED and release the reset button.
      7. Click Upgrade button on the tftp2 utility to do firmware upgrade

      Is it good for any netgear router? The pr2000 trek has no orange led, but 4 green leds, and if I try tftp2 it goes in timeout.

       

      and if I keep pushing reset and turn on the power of the pr2000 the usb green led starts blinking, but again tftp2 goes in timeout.

       

      Nobody else with the same issue?

       

       

      • ElaineM's avatar
        ElaineM
        NETGEAR Employee Retired
        Dec 12, 2016

        If it can't be restored then it's totally bricked.