NightHawk X6 R8000 spits out "Invalid IP address. Please enter it again."

Question

I have a NightHawk X6 R8000Firmware - V1.0.4.84_10.1.84&nbsp;I have a weird error message while trying change the 2.4 Ghz channel.&nbsp;"Invalid IP address. Please enter it again." comes up when I try to apply.&nbsp;When I check the Lan Settings where I have the IP set as 192.168.43.119 and the DHCP enabled for the rest of the LAN and hit apply, the router accepts it with no problem.&nbsp;The only IP address on the Wireless settings is that of the Radius Server which is on my Synology system. That IP works fine with it and I can log in to it with no problems. The Radius Server is successfully logging in all my users. There are no Invalid IPs, what would this be referring to?&nbsp;Any ideas?&nbsp;&nbsp;&nbsp;&nbsp;

FURRYe38 · Answer

What browser are you using? Happens with other browsers?
Does this happen if you set the router IP address pool to default of 192.168.1.1 and do same thing?
&nbsp;
Has a factory reset and setup from scratch been performed since last FW update?

jkexel · Answer

I am using Firefox, I will try another browser and if that does not do it, a factory reset when I have the time.&nbsp;Thanks&nbsp;

FURRYe38 · Answer

👍

jkexel · Answer

What I did finally was to put the gateway at *.*.*.1 ! The router didn't like it at an odd place. That is a firmware issue.&nbsp;

Forum Discussion

NightHawk X6 R8000 spits out "Invalid IP address. Please enter it again."

4 Replies