r6400v2 and CM700

Question

Hi GuysI have some problem with internet , so I just unplug the ethenet cable from my modem and plug it back to router after firmware updated and then it not show me the wifi connect anymore, but it still working good with my laptop by ethenet cable (one of the light on the modem is blinking) . What should I do ? ( my english is bad , hope you guys understand this )

FURRYe38 · Answer

Power OFF the 6400 router then back ON?
Be sure the wifi radio button is pressed to enable the wifi radios on the router.
Try a factory reset and setup from scratch on the router.

QuanH · Answer

thank you so much&nbsp;the radio button is turned off and I just fix it&nbsp;&nbsp;

FURRYe38 · Answer

Glad you got it working. Please mark your thread as solved so others will know. Be sure to save off a back up configuration to file for safe keeping. Saves time if a reset is needed. https://kb.netgear.com/24231/How-do-I-back-up-the-router-configuration-settings-on-my-Nighthawk-routerEnjoy. 📡
&nbsp;

Forum Discussion

r6400v2 and CM700

3 Replies