Problem using HTTP / HTTPS Readyshare

Good morning,
I currently have a problem with my RS700 router (Firmware: 1.0.7.82_2.0.80)
I use readyshare to be able to download my files from the internet to my usb key connected to the router but I encounter a problem when I use the HTTP / HTTPS protocols (No problem in SMB)

If I start a download (2GB file) by connecting via HTTP to the router's Lan IP address, the download starts but it stops after 5 seconds then starts again from the beginning and it happens 10 times approximately before indicating that the download failed.

If I launch a download (2GB file) by connecting via HTTPS to the router's Wan IP address, the download starts but it stops after 5 seconds indicating in Chrome "Network Error"

I tried to change the USB key and also to start the download from other devices but the problem is the same.

Thank you in advance for your help.

14 Replies

FURRYe38
Guru
Jan 10, 2024
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?
Be sure your using a good quality LAN cable between the modem and router. CAT6A STP is recommended.

Does this happen in other browsers as well?

BH_C
- BH_C
  NETGEAR Expert
  Jan 10, 2024
  I believe our Readyshare does not support upload/write through HTTP/HTTPS. You can only upload files to the attached USB storage device through FTP or SMB.
  - Taz40
    Aspirant
    Jan 10, 2024
    Yes, that's what I'm trying to do.
    I forgot to specify that I only had this problem with files larger than 1.5GB
- Taz40
  Aspirant
  Jan 10, 2024
  The problem is not the modem, that's why I specified that I did the test in HTTP on the LAN IP address (RS700)
  - BH_C
    NETGEAR Expert
    Jan 10, 2024
    I wonder if we implemented the HTTP/HTTPS PUT function. We will look into it.

Forum Discussion

Problem using HTTP / HTTPS Readyshare