x-raid nv+ 4 2TB HDD but only show as 2738 GB

---

gcstang2 wrote:
i think it might be this issue https://community.netgear.com/t5/Using-your-ReadyNAS-in-Business/Disk-capacity-expansion-error-resize2fs-Readynas-NV-F/td-p/653186

---

Did you follow the steps there, and determine your block size?

If this is the issue, you will need to do a factory default, rebuild the NAS, and restore the files from a backup.

I started the factory reset the Power light is blinking and screen say's

Booting

"Create C 43.1%"

It's been like this for hours now, is it stuck or should I leave it alone to complete?

---

gcstang2 wrote:

I started the factory reset the Power light is blinking and screen say's

Booting

"Create C 43.1%"

 

It's been like this for hours now, is it stuck or should I leave it alone to complete?

---

I'd check the status with RAIDar also.  You can hover your mouse over the volume and disk icons.

From a Mac I can't find it at all in RAIDar 6.5.0 on Windows it has the old IP address and image is attached but it just say's creating.

If I hover on the icons it just has the sizes and now the power button is pulsating quickly.

Screen on NAS still say's the same as before and the percentage hasn't changed.

About how long has it been?

Over 24 hours

Can you connect the drives to the Windows PC (using either SATA or a USB adapter/dock)?

Turns out there were a few issues.

1. needed factory reset due to diff in block sizes

2. bad disk on position 4

Put in a new disk 2TB and it's resyncing again.

Thx for following up!