Adding a disk to an old Sparc ReadyNAS NV+

---

aris1234 wrote:

I have an old NV+ (Sparc) running Raidator 4.1.14.  I've had two Seagate ST2000DM001's running in XRAID for some time and decided to add a 3rd disk for more space and added redundancy. 

 

---

Three (or four) disks would switch to from RAID-1 to RAID-5.  That will increase space, but it won't add more redundancy.

---

aris1234 wrote:

not quite the same geometry as the old disk as the old ones are 1859 GB and the new one 1860 GB. 

  

---

The new one is slightly larger though, so that should be ok.  If the new disk were smaller, it would be a problem.

There's some old advice here you could try:

https://web.archive.org/web/20160410141326/http://home.bott.ca/webserver/?p=550 wrote:

Login to Frontview and check to see if any apply and temporarily change the setting to what is listed below.

• Frontview > System > Performance > Enable Journaling
• Frontview > System > Power > Disable disk spin-down
• Frontview > Volumes > Volume Settings > Snapshot > Delete any active snapshots & turn off snapshot schedule

After changing the settings go into Frontview > System > Shutdown > Check and Fix Quotas on next boot and expansion should begin.

 

---

You might not see the snapshot settings bit with your firmware - if that's the case just skip that one.

If that fails, you could try removing the new disk and reinserting it (with the system running).  If all else fails you can do a factory reset with all disks in place, and then restore the data from backup.