NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Partition problems after crash
the following problem I have ....
My Nas was about to defragmetieren all my disk until suddenly the power went out and then on all hard disks unfortunately the partition table are messed up
Now I have brought with 1-4 TestDisk 7.0 hard drives back into Linux RAID.
unfortunately does not boot still nas
I have a blank HDD in the slot 1 and pushed installed a new OS but could not match the plates, they were only displayed red
Nas System: RN10400-100eus 4x3TB ca. 70% Daten Raid 5
My Nas was about to defragmetieren all my disk until suddenly the power went out and then on all hard disks unfortunately the partition table are messed up
Now I have brought with 1-4 TestDisk 7.0 hard drives back into Linux RAID.
unfortunately does not boot still nas
I have a blank HDD in the slot 1 and pushed installed a new OS but could not match the plates, they were only displayed red
Nas System: RN10400-100eus 4x3TB ca. 70% Daten Raid 5
2 Replies
Replies have been turned off for this discussion
- I'd contact support (even though they will likely need to charge you).
If you do too much on your own you are likely to do more damage. - The partition table shouldn't get badly messed up with OS6 as we only write changes that are needed. We never rewrite the entire partition table.
I agree with what StephenB said.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
