NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
RNDP4000 No Network Connection or Boot
Hi, Just joined the forum. I've recently purchased a second hand RNDP4000 (diskless) on a spares/repair basis. It was cheap so decided to take the risk. However, I think the Network interface is dea...
Hmmm, definitely not active, so I still think that there is probably a problem with the hardware there.
Will check the drive later, but no reason to suspect it.
I tried each drive bay - same result for each. I noticed there is a green LED on the motherboard that flashes for a few seconds while it starts up, then it goes out and stays out. Any idea if that signifies anything?
The Drive is a 3TB, and there is a label on the back of the NAS that states FW: V4.2.15, so I don't think it is that old, is it?
Have you got a link to the USB recovery procedure, just in case it comes to that? If it does corrupt the EPROM, is that the end of it, or is it still recoverable/usable from there?
Thanks again.
Will check the drive later, but no reason to suspect it.
I tried each drive bay - same result for each. I noticed there is a green LED on the motherboard that flashes for a few seconds while it starts up, then it goes out and stays out. Any idea if that signifies anything?
The Drive is a 3TB, and there is a label on the back of the NAS that states FW: V4.2.15, so I don't think it is that old, is it?
Have you got a link to the USB recovery procedure, just in case it comes to that? If it does corrupt the EPROM, is that the end of it, or is it still recoverable/usable from there?
Thanks again.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
