SeaTools

OK- so I blasted all the dust out of / off of it, and loaded my new disks into the Pro6. Previously, I had a 2 volume set spread across 3, 1T drives. I hope that I haven't made a mistake, but I ended up purchasing 3 new, 1T drives- figuring that I had 3, one went bad but will be warranty replaced in the near future, so while I'm waiting for that I'll just finish off the set with 3 more, 1T drives. That is to say, I now have 5, 1T drives and am waiting on the 6th to be replaced by Seagate. Upon bootup, my Pro6 noticed that I now have 5 drives, but it is proceeding with resync on disk #3 only (disks 4 + 5 are not really being utilized as of yet). Do I need to pull disks 4+5 once the resync is completed and then add them into the mix one at a time, or ?

Thanks