Forum Discussion

Guide

Mar 14, 2018

Admin page issue after upgrade

I have 2 and 4 bay NAS drives. I upgraded from 6.9.2 arm to 6.9.3 arm. Upgrade proceeded normally. After reboot the splash screen indicated 6.9.3 and then "Connection to ReadyNAD Admin Page". The...

Installation & Upgrade

Jürgen

Aspirant

Mar 18, 2018

I have the same problem. After rebooting the volume is inactive and so all shares are not reachable anymore.

I tried disk-check via boot-menu and afterwards I could at least reach the admin-page again. But it shows now that volume is inactive and volume-usage is at 100%. What can I do?

Juergen

ReadyNAS2120v2 with 4x 4TB

mdgm-ntgr
NETGEAR Employee Retired
Mar 18, 2018
Jürgen do you have a backup?

You can send your logs in if you like (see the Sending Logs link in my sig).
- Jürgen
  Aspirant
  Mar 18, 2018
  I have a backup on my old RN2100, but because that one has smaller HDUs, not of all shares. I have a backup of only the most important data.
  As I do backups of my MacOS-clients also on USB-HDUs I could live with loosing the share "Backup" on my 2120, bu therefore recover the rest, if possible in any way.
  - mdgm-ntgr
    NETGEAR Employee Retired
    Mar 18, 2018
    In that case you should contact support.