NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
gramoun
Oct 09, 2015Aspirant
After update firmware 6.4.0, RN10400 doesnt boot
Hi On my RN10400 Nas, i was in 6.1.9 firmware. I update to 6.4.0 using web interface. After update, i accept msg asking for reboot NAS. NAS doesnt respond any more and i have a msg connection loo...
- Oct 09, 2015
Ok finally it work
It s necessary to proceed :
power off the nas by unplug power connector
insert usb stick in front panel
hold backup pressed
connect power to boot
After a few second i had message usb booting
later message usb recovery
after a few minuts, system shut down
i extract usb stick and power on, updating firmawre begin
after 15m i can log in and system is ok without loosing datas
Yeah !!
kohdee
Oct 09, 2015NETGEAR Expert
Just for clarification, you should be holding the Backup button before turning on the unit since the boot menu is on power-on on these units, not after BIOS POST like the x86 boxes. I guess I should clarify that (only for the ARM units).
Related Content
NETGEAR Academy

Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!