NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Broken Nas after os update
Well I think I broke my ReadyNas 102.
I upgraded to Ready Nas Os6.10.10 and now the nas is not reachable and booting into recovery doesnt work.
When trying to reset the powerbutton just flashes 5 times or so and then lights solid with the act led.
Does anyone know if i can recover this ?
6 Replies
Lukas12341 wrote:
Well I think I broke my ReadyNas 102.
I upgraded to Ready Nas Os6.10.10 and now the nas is not reachable and booting into recovery doesnt work.
When trying to reset the powerbutton just flashes 5 times or so and then lights solid with the act led.
Does anyone know if i can recover this ?
What status is RAIDar giving you?
If you need to install java in order to run RAIDar, you should install it from here:
Also, when you power up the NAS are you seeing one of these LED patterns:
LED blink behavior for 2 disk systems is three quick blinks of all disk LEDs and the backup LED, followed by an 1s delay, followed by a number of slow blinks. The number of slow blinks will be the error code. Current error codes: 1 - Vendor mismatch 2 - No disks detected 3 - Bad contents on root partition of disks 4 - Flash error 5 - Unsupported RAID configurationHey,
so raidar tells me "RAIDar could not find any NETGEAR storage on your network. Check that your storage device is powered on and connected correctly."
The nas after I plug it in acts like the following: Act led shines once, then it turns off. After i press the powerbutton the main powerbutton led blinks ~10 times very fast and then all leds are constantly on.
What firmware were you running before you did the update?
Do you have a backup of the data?
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
