NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
[BUG] RAID Resync Progress Output in 6.8.0
In my quest to find half usable iSCSI performance on the 3220 (https://community.netgear.com/t5/ReadyNAS-in-Business/RN3220-RN4200-Crippling-iSCSI-Write-Performance/m-p/1289066), I upgraded to FW 6.8...
StephenB,
You are right, but weirdly it did go away so I thought it was done. However, it is still going at well over 25.5 hours of execution time now against its original 5.5 hour estimate, however the bug still stands. It is now stating -20 hours and over 500% complete.
Clearly it is doing it elsewhere too, although I haven't observed it.
The last time I rebuilt this for that iSCSI thread, as well as two ro three test runs before that, I do not recall such an issue.
If I'm remembering the right iSCSI thread, all your disks are the same size, too, right? If so, you shouldn't have more than one stripe on a factory reset (or re-creating the volume from scratch).
FWIW, I recall seeing this bug before - not sure it if was with beta firmware, or released firmware.
Correct, the sacrificial lamb is 12x4TB @ 7200 and for experimenting ,this time, I decided to build it into RAID10 to see what the IOPS looked like compared to RAID0 last time and RIAD6 before that. So I clean installed it to 6.8.0 and it's evidently just a bit confused on the UI.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
