NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Cannot see the Volumes in NAS.
Hi,
I just added 2 new 3TB HDDS in existing XRAIDs of 2TB each and updated the Firmware but cannot see the Volumes at all.
Error in the events: Volume scan failed to run properly
Please help
I just added 2 new 3TB HDDS in existing XRAIDs of 2TB each and updated the Firmware but cannot see the Volumes at all.
Error in the events: Volume scan failed to run properly
Please help
6 Replies
Replies have been turned off for this discussion
- What firmware are you running? Were the new drives added into empty slots, or did you replace existing drives? Can you give us more details on what you did (hot-insert, power-off insert, etc)?
- Firmware: 5.3.11
I added the HDDs in the empty slots. Hot-inserted.
Now I am getting errors in logs saying: Volume scan failed to run properly - Were the disks used? Did you format them before putting them into the NAS?
What status does RAIDar give you? - Disks were brand new.
RAIDar looks ok, gives me the Setup\Dashboard page
But when i click on Volumes, its empty. - Do you have a backup?
- Having same issue on a NV+ V2. Hard drive3 was failing, replaced VIA Cold swap, when booted, file scan had failed, yet all 4 disks are visible, just can not see the volume.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
