NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Can't get access to the volum.
Hi,
After I removed the disk in my Readynas Ultra 2 (I only got one disc in it) and put it back in it seems like the Readynas won't access the volume. When I check the log it says:
Sat Jan 4 17:08:31 CET 2014 System is up.
Sat Jan 4 17:08:21 CET 2014 The paths for the shares listed below could not be found. Typically, this occurs when the ReadyNAS is unable to access the data volume. media backup
Sat Jan 4 17:07:48 CET 2014 Volume scan failed to run properly.
I tried updating the firmware, but it didn't help.
I have also tried to access it through Windows Explorer, then I am able to see two shared maps (Backup and Media). If I click on either of them I get an error. The error code is 0x80070035.
Can someone please help me and tell me what to do?
Regards
After I removed the disk in my Readynas Ultra 2 (I only got one disc in it) and put it back in it seems like the Readynas won't access the volume. When I check the log it says:
Sat Jan 4 17:08:31 CET 2014 System is up.
Sat Jan 4 17:08:21 CET 2014 The paths for the shares listed below could not be found. Typically, this occurs when the ReadyNAS is unable to access the data volume. media backup
Sat Jan 4 17:07:48 CET 2014 Volume scan failed to run properly.
I tried updating the firmware, but it didn't help.
I have also tried to access it through Windows Explorer, then I am able to see two shared maps (Backup and Media). If I click on either of them I get an error. The error code is 0x80070035.
Can someone please help me and tell me what to do?
Regards
1 Reply
Replies have been turned off for this discussion
- You reinserted the disk with the NAS running???
That will wipe it/do a factory reset.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
