Expansion from 500gb to 2tb became a nightmare (Readynas 110

==== SATA init channel 1
After INIT SATA channel 1, retry=10706, sata=113, status=50
--> SATA Hot add event on chn 1, 63104/60007184
hwif->irq = 33, add 1
No TLER on ST2000DL003-9VT166                      �@
hde: ST2000DL003-9VT166 (s/n:5YD4V8XZ), ATA DISK drive (ATAEXT)
Link drive hde to its hwgroup.
hde: max request size: 512KiB
hde: use capacity 3907029168 sectors (2000398 MB)
Drive support hpa, still should not change max addr.
hde: 3907008688 sectors (2000388 MB), CHS=65535/255/63
hde: cache flushes supported
 hde:chn=1, statu/LP_S=0x(d0/d050)29, 16
 unknown partition table
sata_hotplug: /sbin/hotplug add hdeUser mode helper start.
done do_sata_hotplug
==== SATA init channel 1
After INIT SATA channel 1, retry=30000, sata=113, status=d0
Fail to get ready statu from drive.
Power glitch detected!!!
X_RAID_DRIVE_INIT 1
Disk number= 1: true=1, d=8041db38
Disk number= 1, true device.
Disk number= 2: true=1, d=8041e240
Disk number= 2, true device.
Disk number= 3: true=1, d=8041e948
Disk number= 3, true device.
Disk number= 4: true=1, d=8041f050
Disk number= 4, true device.
life_chn=d, new_chn=2
Init drives on 2
sata_drive_ready: not ready
djo,  chn=1, dj_raid=1, chns=0 source=0 disks=0 parity=0, chn_image=d sector=175616/2ae00,sects=32, need_IO=0
djo1,  chn=1, X_mode=NO_RAID, chns=1 source=13 disks=0 parity=f, sects=175616/2ae00 cmd=0
sata_drive_ready: not ready

Status = d0,chn=1,retry=50000,sata_interface_ready=1, true_d=1
No drive to check, size=0, how_many=0.
hde: status timeout: status=0xd0 { Busy }
ide: failed opcode was: 0xea
hde: status timeout: status=0xd0 { Busy }
hde: status timeout: status=0xd0 { Busy }
Waiting for non-IO result from PIO on hde, cmd ffffffff, drive not ready/td=1
xraid_ide: rq = null.
enable_irq after time out on irq 33
hde: status timeout: status=0xd0 { Busy }
ide: failed opcode was: 0xea
hde: status timeout: status=0xd0 { Busy }
hde: status timeout: status=0xd0 { Busy }
Waiting for non-IO result from PIO on hde, cmd ffffffff, drive not ready/td=1
xraid_ide: rq = null.
enable_irq after time out on irq 33
hde: status timeout: status=0xd0 { Busy }
ide: failed opcode was: 0xe5
hde: status timeout: status=0xd0 { Busy }
hde: status timeout: status=0xd0 { Busy }