NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Initial SetUp of ReadyNAS NV+
I purchased a ReadyNAS NV+ in 2007 (!) and used it with no problems for a number of years. For whatever reason, it was removed from our network and closeted.
Now, I would like to put it back into service. My primary computer is running Windows 9, presumably W10 soon and the other computers on my network are W10. The unit fired up fine, took quite awhile to go through the boot process, but it is alive.
I am unclear how to get started... any assistance would be appreciated.
4 Replies
Replies have been turned off for this discussion
Hi Skai,
Welcome to the community! :)
Click the link below as reference guide about the How-To's in using your ReadyNAS NV+:
ReadyNAS How-To's (RAIDiator 4.x)
Regards,
DaneA
NETGEAR Community Team
Thanks Dana,
The first line, 'Getting Started with RAIDar' comes up with a Page Not Found and judging by the title, it's just what I need. :-)
I downloaded and extracted RAIDiator-V4.1.14.zip I just need a kickstart as I'm not sure what steps to use these files.
Exploring, I found this: http://www.downloads.netgear.com/files/GDC/RND2110/RAIDiator4-1_SW_en_06Dec11.pdf
which contains this:
4. Download the version of RAIDar for your computer. You can download RAIDar at http://www.readynas.com/downloads.
5. Launch the installer and follow the onscreen instructions to install RAIDar.
6. Launch RAIDar.
7. Highlight your ReadyNAS system and click the Setup button.
The 'installer'? Where is this found?Thanks, Dane.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
