NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
New Disk, X-RAID is Dead
I had a drive fail which stopped my unit from booting. I replaced the drive and was able to boot normally. However, on Frontview, the status says "Volume C: Offline, RAID Level , disks, 0% of 0 MB ...
Thanks for the reply!
I did not replace the bad disk when the NAS was powered on because the NAS would not boot (even into support mode) with the bad disk in it.
I have no backup ( I know, I know, bad!).
Mo messages were received about a new disk or resync (although is does see the new disk properly).
I have rebooted the unit several times. I have also left the unit on for an extended duration to see if it needed to anything to initialize the disk.
---
What gets me is that the "resync" button is greyed out and can't be clicked. I even tried reinstalling my firmware.
I did not replace the bad disk when the NAS was powered on because the NAS would not boot (even into support mode) with the bad disk in it.
I have no backup ( I know, I know, bad!).
Mo messages were received about a new disk or resync (although is does see the new disk properly).
I have rebooted the unit several times. I have also left the unit on for an extended duration to see if it needed to anything to initialize the disk.
---
What gets me is that the "resync" button is greyed out and can't be clicked. I even tried reinstalling my firmware.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
