NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Ready NAS Duo RND2110 V2 The Power light, ACT light and both drive lights flash every 5 seconds
My Naz Duo RND2110 v2 has worked perfectly since the end of 2013 when i set it up but out of the blue when it switched on last week i hade the power light, act light and both little green drive light...
Hello silverjay9,
Welcome to the community!
You mentioned you have tried the reset button at the rear panel, do you have full back up of the files? Please note that resetting to factory defaults will not only delete the configuration you have but also all the data.
You can also try connecting the NAS straight to the computer that has the RAIDar. If RAIDar still doesn't see it, remove the disks. (Please make sure you label the disks, it is important that you put them back to their respective bays when you inserting them to the NAS)
Once disks are out, check if RAIDar detects the NAS. If it still doesn't, try another computer. Make sure you are using a known working cable. If all get you the same results, it may be best you contact support to check for it warranty.
Regards,
Do the blinking lights match one of the codes below?
LED blink behavior for 2 disk systems is three quick blinks of all disk LEDs and the backup LED, followed by an 1s delay, followed by a number of slow blinks. The number of slow blinks will be the error code.
Current error codes:
1 - Vendor mismatch
2 - No disks detected
3 - Bad contents on root partition of disks
4 - Flash error
5 - Unsupported RAID configuration
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
