NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
ReadyNAS 2100 'Volume Scan failed on boot'
Hi
Our ReadyNAS 2100 has failed to boot with a message "Volume Scan failed to run properly". (It was powered down properly when the power company arrived to change electricity meters.) The log message refers to shares that have in fact been deleted recently. We are running Raidiator 4.2.22
We run Replicate over to a remote site, so technically we have a back up of all data.
On the front of the unit, only two of the four drive lights are showing.
Any advice welcome
Our ReadyNAS 2100 has failed to boot with a message "Volume Scan failed to run properly". (It was powered down properly when the power company arrived to change electricity meters.) The log message refers to shares that have in fact been deleted recently. We are running Raidiator 4.2.22
We run Replicate over to a remote site, so technically we have a back up of all data.
On the front of the unit, only two of the four drive lights are showing.
Any advice welcome
1 Reply
Replies have been turned off for this discussion
- Apologies for answering my own post. It turns out that sometimes the old ways are the best - I powered it down and took out each disk in turn and re-seated it in the unit. Powered up and the boot found all disks and the boot finished properly (although without a scan). Now up and running.
I think perhaps I should update the Raidiator release and reboot with a volume check.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
