NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
ReadyNas Pro 2 (RNDP2000) failed to boot
Hi all,
After an update (4.2.27 -> 4.2.28) My ReadyNas Pro 2 doesn't boot anymore.
I have tried to fully erase (low level format) my 2 HDD 1To of my Nas, then put them in my readynas & boot into factory default. The Nas switch to install mode (I saw in Raidar) then disapear from raidar and after a couple of day later I can't access the admin page of readynas.
I've tried to install only 1 disk, a do a factory default, creating an X-raid2 area. Same Issue
I've tried to install only 1 disk, a do a factory default, creating no volume area. Same Issue
I don't know if a USB Flash recovery will work. I don't know to do it on a readyNas Pro 2.
If somoene can help me ...
Thank you
As I suspected a file on the internal flash was corrupt. I have fixed this.
This is a problem that can occur in some cases but it would only be an issue when doing a factory default.
2 Replies
Replies have been turned off for this discussion
Hi macgyom,
Try to set it up and connect the device directly to your PC. Also, if you have a spare drive we could further isolate if the issue is with the hard drives or with the ReadyNAS.
Kind regards,
BrianL
NETGEAR Community TeamAs I suspected a file on the internal flash was corrupt. I have fixed this.
This is a problem that can occur in some cases but it would only be an issue when doing a factory default.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
