NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
ReadyNas RN10400 Error do_exit+480
The NAS Admin page under System is now showing error message 'Remove inactive volumes to use the disk. Disk #1,2,3,4'
???
6 Replies
Replies have been turned off for this discussion
HI Ozpete
Welcome to the Community!
RAID have fallen out of sync or might had a disk failure, were you able to download the logs? It would be best to contact Support through my.netgear.com to have a case created and an expert to escalate the case to be resolved through back-end access.
You may have to pay for Support, Pay per Incident Support may be purchased through them.
Hope this helps!
Regards
HI Marc_V,
Thanks for your prompt response.
Looks like I've lost the volume and trying to restart in Read Only bootup hasn't assisted in recovery. Looking at logs from 2 days ago show no obvious drive errors, but dmesg.log from today shows raid array unable to be rebuilt with loss of 3 of the 4 drives which is astounding! Disappointing that no obvious way of detecting any earlier warning signs. As moderator Stephen says in a previous post raid is not a way of preventing data loss although I did buy NAS for greater security. Fortunately I have a recent backup of critical data with the remainder being a write off. Would I be just as well off having 2 large HDDs one backing up the other (with maybe a 3rd as insurance)?
Thank you again for your prompt response.
Ozpete wrote:
As moderator Stephen says in a previous post raid is not a way of preventing data loss although I did buy NAS for greater security.
If you mean me, I'd like to clarify that I am a superuser, but not a moderator.
Ozpete wrote:
Would I be just as well off having 2 large HDDs one backing up the other (with maybe a 3rd as insurance)?
Well, you could go with two larger disks in RAID-1 instead of RAID-5. The drives are mirrored, so either one can be used to recover all the content. That does simplify recovery, as you can try booting the system with either disk (removing the other) if the array gets out of sync somehow. It's also simpler to mount the volume in a different linux system.
I've never used local backup jobs myself. There are several failure modes where they won't help (power surges, physical damage to the chassis, software failures). So I back up over the network to a different device. For instance install a large disk in a desktop PC, and use a PC tool to incrementally back up the NAS to the PC disk.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
