Forum Discussion

Aspirant

Dec 26, 2016

ReadyNAS RN10400 RND-4D - unable to reach mapped share on Win 10 Pro after firmware update to 6.6.0

Hello I have tried remapping the share, looking for an online solution and have tried reinstalling the firmware. I am able to access the NAS via a web browser, but can'tr reach it via Windows Expl...

ReadyNAS OS 6 on Legacy models

JennC

NETGEAR Employee Retired

Dec 26, 2016

Hello Philip_G,

Have you double checked if SMB is enabled on the admin page > System > Settings > Services as well as on all the shares?

If it's already enabled, maybe try disable then enable.

Welcome to the community!

Regards,

Philip_G
Aspirant
Dec 26, 2016
Hi Jenn

Thanks for the prompt reply and the welcome - I'd say it's great to be here, but frankly I only am because I'm stuck!

Yep SMB is running (I even tried running it off and on again). I've allowed anonymous access, I also have NFS, AFP, FTP as well as HTTP active and I've given read/write access to everyone.

I've rebooted it numerous times as well as the router/modem it's attached to, this PC and the Mac as well.

I'm stumped.
- StephenB
  Guru - Experienced User
  Dec 26, 2016
  Try using NAS admin credentials on the windows PC and see if that works.
  - JennC
    NETGEAR Employee Retired
    Dec 26, 2016
    Hello Philip_G,
    
    Are you getting error message when trying to map the NAS IP?
    
    Regards,