Recovery

---

Marc_V wrote:

miogpsrocks

 

Have you checked if the NIC port has LED indicators? or have you performed any update recently? If the drives are healthy, it might be the chassis that's having the issue and may need to be checked.

 

Do you notice if the NAS boots normally? If not  doing a USB recovery might help. Contacting Support is also advised.

 

Regarding data recovery a lot of users here might recommend ReCLAIMe, ddrescue, r-linux.

 

HTH

 

Regards

---

The lights are on the NIC card.  I pulled each hard drive and looked on Crystal disk info and it showed as healthy then I ran a short generic test using Seatools and it all showed up as good. 

The device sometimes has started up where I could see the device on Raidar software however the file browser shows up as Empty. 

Other times I have check and I have access to the files but ability to access the files drops off soon after I try to back them up. 

With Reclaime, I have 6 hard drives in this device but I believe only 4 SATA connectors in my PC and one is being used for current OS. 

Can I make some kind of virtual drive Clone 1 by 1 of each Hard drive then use the software to run whole RAID magic formula combination  that will turn that into data files? 

How do I manage 6 drives in the recovery software when that exceeds the number of SATA ports in the PC? 

Thanks.