Forum Discussion

Aspirant

Feb 09, 2018

Solved

RN316 touch pad lights itself after opening and closing the door

Hi, If I open the door (the one with the touch pad on it) to the left most (at maximum angel), and then close it, the touch pad gets lit by itself. If I open the door at a smaller angel and close...

LED

Other Discussions

Marc_V
Feb 14, 2018
Hi fatmonk

The lights should stay off when you are not touching the pad or like what Sandshark mentioned, the proximity sensor is being triggered.

it is possible that the sensor is being triggered automatically or by your hand/object, or by the shake of the door when being closed.

fatmonk

Aspirant

Feb 12, 2018

wrote:
It's designed with a proximity sensor. When you open it all the way, your hand or a nearby object is likely getting close enough to set it off.

Thanks for the reply.

Did you mean my hand was close enough to set it on? Becuase the lights cannot be manually turned off, they can only go off after timeout if no further operation on the touch pad.

So when I close the door, should the lights on by themselve or not? I have tried holding only the edge of the door to make sure I didn't triger the sensor, but still the lights auto turned on when closing the door. I'm not sure if this is by design.

Marc_V

NETGEAR Employee Retired

Feb 14, 2018

Hi fatmonk

The lights should stay off when you are not touching the pad or like what Sandshark mentioned, the proximity sensor is being triggered.

it is possible that the sensor is being triggered automatically or by your hand/object, or by the shake of the door when being closed.