Forum Discussion

Luminary

Jul 28, 2017

Solved

Share not showing in Frontview

Ultra with OS6 6.7.5 I created a share in Frontview as per normal procedure. As I don't run windows I only gave it nfs and rsync access with the normal ip addresses I use and the normal owner an...

ReadyNAS OS 6 on Legacy models

StephenB
Aug 01, 2017
How about btrfs subvol delete /data/Backups_Weekly_of_212/.snapshots

JennC

NETGEAR Employee Retired

Jul 31, 2017

Hello davidr1,

Could you check if you will get the same results when you use another web browser? Perhaps you want to try creating a new share again leave SMB enabled also then check if you get the same results.

Regards,

davidr1
Luminary
Jul 31, 2017
Thanks for replying JennC,
It happens in other browsers as well.

I can create and see new shares - already did this but did not configure with smb - none are.

Can I just delete it from /share using ssh or is it registered in a database of shares or something?

Also, if I do a factory reset using OS6 on the Ultra, which OS would it reset to?
- JennC
  NETGEAR Employee Retired
  Aug 01, 2017
  Hello davidr1,
  
  Yes, you can try
  
  rmdir <sharename>
  
  And then create a share
  
  rn_nml [-v] -a share:/data/<sharename>
  
  I believe this should show the share on admin page and SMB is enabled by default.
  
  Regards,
  - davidr1
    Luminary
    Aug 01, 2017
    Thanks JennC.
    If I factory reset the Ultra which uses OS6 would it reset to OS6?
    I can't find any info on this.