I tried to connect WAX220 with HPE 1910-8G-PoE+ (180W) JG350A swich but without success.
I can see "Insufficient Power. Check if AF power is connected instead of AT Power. Turned off both 2.4GHz and 5GHz radios. Connect AT/PoE+ switch for full operation." so I think there is some problem during PoE negotiation between switch and AP. Switch is connected to patch panel and distance between patch panel and AP is approximately two meters.
Output from switch :
LLDP local-information of port 3[GigabitEthernet1/0/3]: Port ID subtype : Interface name Port ID : GigabitEthernet1/0/3 Port description : GigabitEthernet1/0/3 Interface
Port VLAN ID(PVID): 1
Port and protocol VLAN ID(PPVID) : 0 Port and protocol VLAN supported : Yes Port and protocol VLAN enabled : No
Power port class : PSE PSE power supported : Yes PSE power enabled : Yes PSE pairs control ability : No Power pairs : Signal Port power classification : Class 4 Power Type : Type 2 PSE Power Source : Primary Power Priority : Critical PD requested power value : 25.5(W) PSE allocated power value : 25.5(W)
Link aggregation supported : Yes Link aggregation enabled : No Aggregation port ID : 0
Maximum frame Size: 10240
MED information Media policy type : Unknown Unknown Policy : Yes VLAN tagged : No Media policy VlanID : 0 Media policy L2 priority : 0 Media policy Dscp : 0
PoE PSE power source : Primary Port PSE Priority : Critical Port available power value: 30.0(w)
