Orbi WiFi 7 RBE973
Reply

TFTP program reset CAX30

Bricked1234
Aspirant

TFTP program reset CAX30

Hi I have attempted the TFTF fix, has not fixed the problem but noted a few things if anyone worked or has feedback. 

 

General note 

When I reset the router and the 2 ethernet cable light turns on my ethernet connection goes to identifying to unidentified network but once the 2 turns off it goes back to network cable unplugged. ( I am plugged into port 1, and when i plug into port 2 light 3 turns on) 

 

Fix through windows command prompt 

press enter after resetting for 30 seconds. (tftp -i 192.168.1.1 put CAX30-V1.4.11.2.bin)

Will pending for a period of time and then give "Connect request failed"

Tried about 10 times

 

Using the NMRP solution 

nmrpflash.exe -i net5 -f CAX30-V1.4.11.2.bin in command prompt. 

New window pops up says its looking for ethernet connection then 

Advertising NMRP server on net5 ... |

Then "no response after 60 seconds bailing out" 

This is said  short time after the 2 light turns off. 

 

 

Any feedback? 

Thanks 

( did manually set the IP in TP4 like both instructions  told me) 

Message 1 of 2
FURRYe38
Guru

Re: TFTP program reset CAX30

Seems like your unit is in a full on bad state.

Please make contact with the forum moderators so they can help you from here on out:

https://community.netgear.com/t5/Cable-Modems-Gateways/My-Nighthawk-CAX30-Cable-Modem-Router-is-not-...

 

@ChristineT @DarrenM 

Message 2 of 2
Top Contributors
Discussion stats
  • 1 reply
  • 581 views
  • 0 kudos
  • 2 in conversation
Announcements

Orbi WiFi 7