- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
USB connected UPS
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
USB connected UPS
Had been using Cyberpower CP1500AVRLCD UPS for the last couple of years with this ReadyNAS thru a USB connection. Sometime this year with the firmware update now at 6.9.1, the USB connect to UPS appears no longer supported.
Tried adding UPS and there is no USB option. The only options are SNMP and Remote UPS. Please advise how I can configure the UPS using the USB option that was available in the past. Thanks!
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: USB connected UPS
A UPS connected via USB should be automatically detected and used without needing any configuration.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: USB connected UPS
It should show up if you expand the UPS section of the power tab. I did that, and then clicked on the settings wheel, and see this:
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: USB connected UPS
Thank you for your suggestions. Just changed the UPS USB connection to the rear USB instead of the front and now it recognized it. Not sure why it does not work with the front USB.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: USB connected UPS
Does it detect a USB hard disk properly if connected to the front USB port?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: USB connected UPS
I guess the front USB port no longer works. Anyway to revive it? This is a first time that I have encountered a USB port that failed.