Model EX7300v2 after power outage

Question

We had a momentary power outage last night, so short that nothing was affected but my EX7300v2.&nbsp; The power light has been flashing green since then, indicating that it is rebooting, but otherwise the extender is dead.

plemans · Answer

Its just constantly flashing green?&nbsp;
Did you try factory resetting it? Push and hold reset for 7-15 seconds while its powered on.&nbsp;
If that doesn't work, you can try recovering it with tftp or nmrpflash. are you on windows? if so, follow this guidehttps://kb.netgear.com/000059634/How-to-upload-firmware-to-a-NETGEAR-router-using-Windows-TFTPjust make sure you enable tftp https://www.thewindowsclub.com/enable-tftp-windows-10and here's a video walk through using a tftp client. Use the built in one for windows 10 though. the video is more of an example of how its done. https://www.youtube.com/watch?v=R9DLrLQrpawand if that doesn't work, you can try using nmrpflashhttps://github.com/jclehner/nmrpflash

Forum Discussion

Model EX7300v2 after power outage

1 Reply