Port forwarding does not take effect

Question

HiWhen I setup port forwarding on my Orbi unit, it does not take effect.I have forwarded the following ports to our PS4 console&nbsp;&nbsp;80, 443, 1935, 3478-3480, 3074, 3659, 6000, 10000-10150, 42127But when I test from the outside, it says the ports are closed, and the PS4 also does not recognize this, it reports NAT-3.Port forwarding worked fine with our previous router, an ASUS RT-AC87U.&nbsp;I have tried with UPnP both On and Off, same problem.What could be the reason, how to fix it?&nbsp;&nbsp;

CrimpOn · Answer

Magixians&nbsp;wrote:There is no modem. Router connected directly to WAN.The Orbi router has to be connected to something.&nbsp; The Orbi has no connector for coax cable or for a fiber.&nbsp; The WAN (yellow) port must connect to some ISP device.&nbsp; Knowing the specific brand and model helps eliminate some possibilities.

FURRYe38 · Answer

What Firmware version is currently loaded?What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?

Magixians · Answer

Firmware is V2.3.5.30There is no modem. Router connected directly to WAN.

FURRYe38 · Answer

What browser are you using?&nbsp;Be sure to clear all browser caches before entering into the RBRs web page.&nbsp;&nbsp;Has a factory reset and setup from scratch been performed since last update?

Magixians · Answer

YesThree different browsers tested. But that shouldn't make any difference since the router reports the setting correct in the web browser even in a new browser that I tested. It just doesn't work when tested from either end.

Forum Discussion

Port forwarding does not take effect

10 Replies