Forum Discussion

Aspirant

Nov 06, 2018

Having trouble changing network management IP and subnet mask on GSM7224v2 switch

I am having trouble changing the network management IP and subnet mask on a Netgear GSM7224v2 switch. When I use the network parms command the error I get says, "IP Address/Netmask entered conf...

Troubleshooting

bremke

Aspirant

Nov 12, 2018

Thank you, DaneA. I will give that a try.

bremke

Aspirant

Nov 12, 2018

In privileged EXEC mode the command "network protocol none" results in the IP address, subnet mask, default gateway, and Configured IPv4 protocol being reset as expected.

(GSM7224V2) #show network

Interface Status............................... Always Up
IP Address..................................... 0.0.0.0
Subnet Mask.................................... 0.0.0.0
Default Gateway................................ 0.0.0.0
IPv6 Administrative Mode....................... Enabled
IPv6 Prefix is ................................ FE80::E291:F5FF:FEA8:B370/64
Burned In MAC Address.......................... E0:91:F5:A8:B3:70
Locally Administered MAC address............... 00:00:00:00:00:00
MAC Address Type............................... Burned In
Configured IPv4 Protocol....................... None
Configured IPv6 Protocol....................... None
IPv6 AutoConfig Mode........................... Disabled
Management VLAN ID............................. 2

But the "network parms" command doesn't work. I get a message back saying "IP Address/Netmask entered conflicts with the configured IP Address/Netmask of a router interface.

DaneA
NETGEAR Employee Retired
Nov 13, 2018
bremke,

If ever the GSM7224v2 switch is currently connected to the existing network, kindly disconnect it for the meantime then proceed with the network parms command.

Let us know the result.

Regards,

DaneA

NETGEAR Community Team