m4300 dante profile template sets policy on unselected ports

I was going through the Netgear AV setup guide for Dante traffic. Factory reset switch, nothing configured on it at all except the serviceport IP.

https://www.google.com/url?sa=t&source=web&rct=j&opi=89978449&url=https://www.downloads.netgear.com/files/GDC/Managed_Switches/Documents/Configuring-Dante.pdf

Using the Audio Dante profile template and setting up a new VLAN using the AV gui login, and checking only a few ports to be configured this way. It noticed it creates various class maps and classes, but then it appears to apply this POLICY_AV to every single port on the switch, instead of just the ports I had selected to be in the VLAN. This seems like a mistake to me, as while I do want dante traffic on these ports, I don't want the same on other ports I haven't configured yet or selected. In this case I only selected ports 13 to 16, but it's on all of them. The vlan is only set on 13-16 as expected.

interface 1/0/10
service-policy in POLICY_AV
exit

interface 1/0/11
service-policy in POLICY_AV
exit

interface 1/0/12
service-policy in POLICY_AV
exit

interface 1/0/13
service-policy in POLICY_AV
vlan pvid 182
vlan participation exclude 1
vlan participation include 182
exit

interface 1/0/14
service-policy in POLICY_AV
vlan pvid 182
vlan participation exclude 1
vlan participation include 182
exit

Anyone seen this behavior before? Running the current latest 12.0.17.19