NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
MLag and LACP configuration on M4500 (using CLI)
Hello, I am New to Netgear and i want to cofigure MLAG and LCAP to my Switch M4500-32 C But i did not find proper Doc which give command referance if someone can guide the configuration using CL...
Thanks it was very helpful and productive answer
I need more help
We have connected 4×10 40G DaC cable to ubiquiti but unfortunately ubiquiti switch are not getting IP and link which is connected to DAC is down
Cloud you suggested something with configuration
Is it a QSFP+ 40G breakout DAC cable that you are inserting into one of the QSFP28 100G ports of the M4500 CSM4532?
The portmode command is used to configure QSFP28 interfaces with 1x100G, 1x40G, 4x25G, or 4x10G. If you are using portmode 4x10G here, we may have interop issue with the breakout DAC cable; or with the way the third-party switches handle it on the other end.
Please upgrade the M4500 CSM4532 switch with latest software:
https://www.netgear.com/support/product/m4500-32c#download
Please use the release notes for the method updating the firmware.
With the latest software, you will have the AV User Interface, and it will be easier to produce the Tech Support file (Diagnostics/Support Diagnostics). In the TS file, there are all the show fiber command that will help understand the problem on the port / DAC.
Thanks for you quality Time today we are going to check again and also going to change breakout DAC to single one into one DAC or AOC
upgrading the firmware as well
Again Thanks
Hi asifshaikh04
You are opening several threads so it doesn't make it easy. I answered these questions in DAC cable between netgear and ubiquiti USW 48 po... - NETGEAR Communities
The portmode 4x10G command is creating 4 new ports. These new ports need to be configured, added to LAG, as any other port. The port numbering is different for them. The tech-support file will help us understand where you are and what to do.
Please the use the Software Administration Manual page 43 to see the port numbering of the 4x10G in your case. I believe you need to configure LAG on these new ports. https://www.netgear.com/support/product/m4500-32c#docs
So your 100G port is detach because it's breakout to four other ports later on. You need to configure the other ports, form LAG etc.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
