NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
DHCP Relay with VMWare DHCP Server
We have a Virtual DHCP server and I'm trying to configure the DHCP Relay on our L3 switch so all VLANs can get an IP Address but cant seem to get it to work. Any advise would be great.
Would you happen to have any documentation/guide on this? In particular, how do you enter wildcards? eg if you wanted a subnet or any protocol or any port or any ip address etc.
Hi SCGSGAog,
Let me share these articles below as reference guides:
Regards,
DaneA
NETGEAR Community Team
This isnt clear in regards to defining a subnet, dont know how to set it for any protocol or port (L4 that is).
Thank you for the manual but again it doesnt tell me how to specify 'any' or 'all' parameter. I'll rephrase my question, How do restrict all traffic except DHCP? please provide examples.
Hi SCGSGAog,
As per the ProSAFE Managed Switch web management user manual, there is a note:
Also, from the article(s) I have provided, it shows where to enter the Protocol Type and the Port Number:
For further assistance, you may open an online case with NETGEAR Support at anytime. The NETGEAR Support expert may opt to schedule for remote session in order to assist you in setting up the parameters needed.
Regards,
DaneA
NETGEAR Community Team
Yes I was aware of the implicit deny all, I was just thinking ahead where I might need to define something with any/all parameter beit subnet, protocol or port but nevermind I'll just log a case with support.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
