brick JGS524PE

Hello!

Why Do You think it need to be replaced? Are You Expect Any HARDWARE Problem????

1- if yes then I can replace broken chip - main uC or another ?

2- if not - is firmware problem i can blow new one

The program is in MX25L3206E-12G, and this is 32mbit flash memory. If this content is broken, then I can reflash it using any external flash programmer form provided HEX file

also board include Nuvoton M058SLAN 32bit arm micro controller, if this is problem then also I can re-flash if needed, but it looks like this is more for LED control and FAN

3- if this forum does not have enough qualified person to understand problem on electronic level, then I will need link to correct support team to get guide on next level

4- If 1 -3 not applicable - then I need to transplant flash content from another working unit and share solution with others user on the forum, because problem is common and frequent, but I can’t find any solution other than - if is broken buy new one, or replace on warranty by NETGAR - similar and booth are NOT ENVAIOMATNATL FRENDLY, we produce more electronic rubbish instead fixing them and using again

 Regards

Old fashion engineer ;-)