Forum Discussion

Aspirant

Mar 03, 2022

Can ping everything on the internet but cannot access any webpage. Timing out

Hi. I`m new to Netgear switches. Got a bunch of ProSafe GS728TPv2 that I have configured to be like this. User PC (VLAN 10)-- VoIP Phone(VLAN20)--Firewall--Internet. The Users which is in VLAN...

JeraldM

NETGEAR Employee Retired

Mar 03, 2022

davmerc1,

Welcome to the community!

Try enabling domain lookup by typing "ip domain-lookup" on the CLI.

For further assistance, you can open a support case here.

Regards,

JeraldM

NETGEAR Community Team

davmerc1
Aspirant
Mar 04, 2022
Hi JeraldM

Thanks for the reply.
Apologies the model is GS728TPP. I believe there is no CLI on that model?
- schumaku
  Guru - Experienced User
  Mar 04, 2022
  davmerc1 wrote:
  
  Apologies the model is GS728TPP. I believe there is no CLI on that model?
  
  According to the config posted it's a v2
  
  SYSTEM CONFIG FILE ::= BEGIN ! Model: GS728TPPv2 ...
  
  Since a recent firmware update, the Light CLI was added - consult the https://www.netgear.com/support/product/GS728TPPv2 FMI.
  
  However, the command JeraldM proposed (available typically on managed switches only) is to enable the DNS resolver on the switch management, allowing to use FQDNs e.g. for NTP servers, SNMP trap receivers, ... and has absolute no impact on the switch data traffic. On your current startup FWIW it's disabled by the "no ip domain lookup" - the control is on the DNS Configuration -> DNS Status [x] Disable Enable.
  
  From wally brain, there is no such control on the Light CLI.
  
  Connecting the PC direct to port 1..21, does it allow the Internet access as expected?
  
  Suspect there is some VLAN config inconsistency on your devices and network.