Forum Discussion

Aspirant

Oct 31, 2023

Netgear FS728TPv2 PNP

Can I just use Netgear FS728TPv2 as plug and play without using the configuration control center... just need the switch to power a couple poe cameras added to my home network.

FURRYe38

Guru - Experienced User

Oct 31, 2023

Yes. I'd check documentation of the switch and cameras to ensure if POE can be serviced with little or no user configurations needed. Some maybe needed.

notqytryt
Aspirant
Oct 31, 2023
The reolink cameras are plug N play.. I just now have to figure out how to get the switch to go into "open mode"... (meaning do I have to configure it with software or just reset it)
- schumaku
  Guru - Experienced User
  Oct 31, 2023
  With the default config, there is no port security, no ACL, no 802.1x - works like any generic (unmanaged) switch.
  - notqytryt
    Aspirant
    Oct 31, 2023
    Thanx I was hoping that was the case... I just need the poe ... the switch was cheaper for me than 3 adapters.. and this is definitely an easier way to go....