WN2500RP - Pot forwarding?

Question

I've been using a WNDR3700 with a few cameras. I use port forwarding to get to each camera remotely.

I just added a WN2500RP extender.

Can I connect cameras to extender? and do I need to re-establish port forwarding?

I'm a bit confused conceptually.

Thanks

jmizoguchi · Answer

whatever the IP that camera needs to be reached is not different than before. use the IP that you can view on LAN to the camera and forwarded

shadysprings · Answer

jmizoguchi wrote:whatever the IP that camera needs to be reached is not different than before. use the IP that you can view on LAN to the camera and forwardedThanks.  So I would connect cameras to new SSID of the extender, and everything else stays the same I believe.  The camera IP addresses are fixed and stay the same, the router still forwards the respective port to each cameras IP address now through the extender.Think I got that right.  Maybe I'm over thinking this.

jmizoguchi · Answer

As long as you can reach with whatever IP is the then you it's working.. and that IP is still need to forwarded

jrswanson91 · Answer

I am trying to port froward from my netgear&nbsp;WNDR3400v2 to&nbsp;WN2500RPv2 then to my computer at 192.168.1.10. I cannot find a way to forward from the WN2500RPv2&nbsp;to my computer. I can only port forward with the WNDR3400v2&nbsp;to the computer. But that is not working. Can either of you help? I see this is an old thread but nothing else is online to help.

nhann · Answer

Please see:
https://community.netgear.com/t5/General-WiFi-Routers/wn2500RP-Port-Forwarding/m-p/994639#M59679
for discussion about this issue

Forum Discussion

WN2500RP - Pot forwarding?

5 Replies