NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Can not connect to my NetGear Ready NAS Duo V1 (RND2000)
Hello,
I'm new here.
I have some problems with mij NetGear Ready NAS DUO V1. I give my NAS a Factory reset. After reset the NAS has get a DHCP adres. I can ping this adres. But i cannot conne...
You can't connect to the menu unless disks are installed and functioning. If you are doing initial setup (or a factory default), the system might still be setting up the RAID array. It generally will be non-responsive for a while when it is doing that.
Try using RAIDar on a PC, it should be able to discover your NAS and give you some basic status. https://kb.netgear.com/20684/ReadyNAS-Downloads
Also, there could be some information in the blinking leds. Here's the decoder ring:
LED blink behavior for 2 disk systems is three quick blinks of all disk LEDs and the backup LED, followed by an 1s delay, followed by a number of slow blinks. The number of slow blinks will be the error code.
Current error codes:
1 - Vendor mismatch
2 - No disks detected
3 - Bad contents on root partition of disks
4 - Flash error
5 - Unsupported RAID configuration
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
