Forum Discussion

Aspirant

Apr 16, 2023

Solved

Netgear ReadyNas New User - Setup issues

Hi, I have recently purchased 2nd hand a Netgear READYNas Duo 2 and been able to: Install Drives Reset the system Updated the Firmware to 5.3.13 But I still cannot access the drive v...

eton
Apr 16, 2023
To bypass the error message `SSL_ERROR_UNSUPPORTED_VERSION`, do this in Firefox:
Open the address: about:config
Change security.tls.version.min to 1.
Reload the page with the error message or open the address {NAS IP}/admin
I don't know how to do this i Chrome.

(Your attached attached images are not visible.)

eton

Luminary

Apr 16, 2023

To bypass the error message `SSL_ERROR_UNSUPPORTED_VERSION`, do this in Firefox:

Open the address: about:config
Change security.tls.version.min to 1.
Reload the page with the error message or open the address {NAS IP}/admin

I don't know how to do this i Chrome.

(Your attached attached images are not visible.)

StephenB
Guru - Experienced User
Apr 16, 2023
eton wrote:
I don't know how to do this i Chrome.

You can't. But both Internet Explorer and Edge in IE mode will work. More info is in this thead:

https://community.netgear.com/t5/New-ReadyNAS-Users-General/Workaround-for-ERR-SSL-VERSION-OR-CIPHER-MISMATCH-problem-for/m-p/2198243

Vapebear once you regain access, you can install this add-on:

https://github.com/rdynsxtrs/r5bin/blob/master/apache2/Apache2_2.2.34-arm-0.0.1.bin

That will install TLS 1.2 on your NAS, so you won't need to continue with FireFox.
Vapebear
Aspirant
Apr 22, 2023
Thank you for the solution - I have now been able to access the drive and start the set up process 🙂
- eton
  Luminary
  Apr 22, 2023
  Glad it worked.
  
  You can also have a look at the other solution where you install an add-on.
  
  Now I can see your attached images. Maybe the forum needed some time to process them.
  - StephenB
    Guru - Experienced User
    Apr 22, 2023
    eton wrote:
    
    Now I can see your attached images. Maybe the forum needed some time to process them.
    
    FYI, all embedded images need to be reviewed/approved by a mod before they are seen. That can take a while (depending on how busy the mods are).