NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Service Action to Prevent PSU Failures in ReadyNAS NV/NV+
A Service Action notice has been posted in the Announcement forum to prevent ReadyNAS NV and NV+ systems from premature power supply failures at viewtopic.php?t=10259. If you own a NV or NV+ within t...
I installed the EnableFanMinRPMOverride add-on and set it to 2100 rpm.
After a recalibration the fan speed is around 2200 rpm but it emits a slight clicking hum wich is a bit annoying as I have the NV+ on my desk.
The clicking disappears if I set a minimum speed below 2000 rpm (1900-1800 rpm).
The temperature didn't fall that much. Just a 0.5 degree lower both on board and on disks (before the fan speed was about 1700-1800 rpm).
I have two disk tray still unused as there are only two drives in my unit.
Do you think removing them could help psu dissipation?
Thank you
After a recalibration the fan speed is around 2200 rpm but it emits a slight clicking hum wich is a bit annoying as I have the NV+ on my desk.
The clicking disappears if I set a minimum speed below 2000 rpm (1900-1800 rpm).
The temperature didn't fall that much. Just a 0.5 degree lower both on board and on disks (before the fan speed was about 1700-1800 rpm).
I have two disk tray still unused as there are only two drives in my unit.
Do you think removing them could help psu dissipation?
Thank you
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
