NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Firmware update from 6.8.1 to 6.9.0 - now disk 4 is throwing (ATA failing disk) warnings
I ran firmware update successfully last night, and rebooted the NAS. Instantly, the below alert started occurring - twice per minute - as if the test itself is creating the error count. Detected...
The NAS device is barely utilized to begin with, and no, it's not doing any sync, balance, backups, or much of anything for that matter. 760GB used, 2.00 TB free, and snapshots are on, and will continue to run until 95% full. That may take longer than paying off my mortgage at this rate....
It wasn't a physical power reset, it was restarted through the GUI. This is why I tended to believe that it was a new Firmware issue. The next time I consider installing firmware updates, I plan to restart the device first, and see if anything throws an error or warning. If not, then I have further data to say that it was not the hardware.
You said it was "as if the test itself was creationg the error". Well, it was writing each of those failures to the log, and those writes could be the source of more errors.
An ATA error can be caused by an external source, though the SMART will log it as a fault because it can't tell. But I know of no way that a firmware error could cause that unless they are false alarms. I have only seen them as a hardware issue. And if they are false alarms, then the SMART data for the drive should not show them.
While the firmware update, which writes to the OS partition, and then the log entries, that also write to the OS partition, may have been a catalyst, the root cause of the error is almost certainly hardware. If you don't want to travel there now, you should at least make sure your backup is up to date in case things get more dire.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
