Fried(?) ReadyNAS NV+ #19179228

I do have a case logged in at Tech Support but have thus far received only an acknowledgement two days ago and and notification 1 day ago that they will need more time. Since then nothing. When I originally restarted the device with a single bare drive, it booted normally, and before I shut it down I thought it advisable to authorize it to perform a volume scan on start up. Short of powering it down and rebooting it with a bare drive once again to reset that switch, can you think of any way to tell it to skip the volume check on boot? I should add that I would occasionally check the smart data on the drives, and to the best of my recollection the ATA errors reported for the 320ES are about (probably exactly) what the ATA error count was on that drive before the P/S failure. I do not think that either 630AS had reported any errors; it's at least conceivable that the ATA error now reported on one of the the 630ASs occurred when the P/S failed.